Autran DX III (H). Autran MBX. Bucher + Cie AG. Motorex ATF Dexron III H . SKL ATF B (J/). Dexron VI ATF (J). Slovnaft JS Co. Autran – Castrol – PDS & MSDS Search. Text; Aquatic, · Exposure, · Belgium, · Regulation, · Annex, · Environmental, · Disposal, · Autran. OIL BP AUTRAN MBX 53KG DRUM – AUTOMATIC TRANSMISSION BP SUPER OUTBORD SPEZ B 12X1 LTR OIL BP VISCO 10W
|Published (Last):||28 November 2009|
|PDF File Size:||1.75 Mb|
|ePub File Size:||13.96 Mb|
|Price:||Free* [*Free Regsitration Required]|
However, over a period of time as the synthetic oil meets the O ring it tends to leech out the traces of mineral oil the O ring had absorbed, but the synthetic does replace this oil, with autrab result that the O ring disintegrates into a snotty mess, and leaks then develop. If anyone would like a copy of the full document which covers many of the other gearboxes, send me a PM with their email address and I will reply with a copy of the full pdf document.
The following oils are suitable for these gearboxes List from ZF was dated Feb The full ZF oil list https: Technically Dexron ll and lll no longer exist – GM who own the names and technical authority have discontinued support.
When you read through the many postings there have been on this and many other sailing and marine forums, there are warnings of issues with the clutch plates slipping when using ATF Synthetic oil and that is what I have. However, in the list above there are oils mentioned which are fully synthetic so I may just bite the bullet. This has led to some incompatibility problems even within the Shell catalogue.
ЧАСТО ЗАДАВАЕМЫЕ ВОПРОСЫ
The list was dated Feb You aren’t likely to buy DVl by mistake, I don’t think it’s widely seen on accessory shop shelves and is very expensive. ATF is what is called for! Oil incompatibility with elastomer O rings is not a problem that shows itself immediately, and this is a problem well known and documented within the refrigeration industry.
I have recently being trying to sort out which oil to use in my Hurth HBW gearbox and have received this information from ZF in Germany which is a transcript from a larger document. I think that also used to have ATF specified.
Car parts | car awaiting parts | | Oils, lubricants and fluids | Gear oil
The current Tellus range differs enormously from what it was 20 years ago, for example. Well an O ring that has been atran contact for many years with mineral oil will likely have absorbed some.
I understand that DVl is not recommended for mechanical clutch gearboxes – too slippery. I can see the logic of keeping to the same oil type so will be changing my bottle of Halfords autgan synthetic to straight ATF.
When the oil is changed only the free oil drains out, leaving that absorbed into the O ring where it is. To some extent its an age thing, not the oil, me!
Thank you for the post on oil seals which was my main worry. I cannot quote you gospel but believe this is why VP changed to specifying engine oil aitran of ATF for gearboxes and saildrives, in case anyone used DVl instead of Dll or Dlll.
However equivalent of Dlll is readily available from any car shop under lots of names. I cannot speak for any other oil manufacturers but the composition of Shell grades has changed markedly over the years.
It would be interesting to know how regularly that list autrqn updated. Ignore the ZF number at the end as that is the ZF approval number. A typical nitrile O ring will absorb mineral oil, but not certain synthetics. This was a widespread problem in extensive systems that for instance supermarkets use, and 6 – 18 months after oil change the problems of leakage became obvious. Therefore returning to the subject of what ATF to use, then it may pay to avoid a synthetic in a box always previously ahtran with mineral base ATF, if an alternative mineral base remains available.
I gather from Wiki that there is no Dexron D-IV grade it was never approved by GMthough there is a D-VI which is of slightly lower viscosity than D-III when new, but with lower permitted xutran loss from shearing in use — so the allowed final viscosity is the same.